Kira's Ocean Wave Scarf
by N Banks 20221
Rigid Heddle Pattern
10 dent heddle
warp was 95 inches long, with 76 warp ends.
7 inches wide, 65 inches long and 4 inches of fringe at each end.
plain weave
I hemmed stitched it at the beginning and end before taking off the loom.
For the warp I used a sport weight red heart yarn in a pale green color but I would say it was more like an aqua marine color than pale green which is why I used it.
Weft yarn
I used four colors
1. Red heart ombre in scuba
2. Baby Bee Aqua Marbled
3. Red Heart white
4. Snowflake in white.
I just wove it plain and charged colors when I wanted to, starting with the dark Red Heart Scuba, then the baby bee aqua, then white and then the snowflake ( top of wave)
Pattern Notes: I didn't count the rows but did keep track of the inches as I moved along. I use a wide 2 inch ribbon for a rule, (saved from a blanket from Walmart) I just marked off each 1 inch section. I also use a paper towel cardboard cut up the middle to cover the tie on knots. Also when sleying the reed I tie of sections of the warp with a very loose overhand knot just in case the reed falls off the loom while I am working.
I like to do a color card with the names and samples of the yarn that I use. Below is a picture of the color for this scarf. Sometimes on the back I will add details about the draft or pick up pattern I am using or any other information I may need. (clip on it holds more cards from other projects I have done)
Before staring I like to mark off my reed like below. It shows were I start to slay the reed and were I need to end it.
Below are some pictures as I worked on it
slaying the reed tie on
Starting to weave and it also shows the paper towel roll I use to cover the knots, you can see them on the tie on (above) picture.
I also like to do a sheet with the name of the person I am making it for and figuring out the math etc part of it. On it I will list information about the yarns, which one to start with etc. The pickup pattern if I am using one. I keep it by my loom and work from it as I go. Also number of warp ends and length of the warp. This way I can re-figure it if I need to or use the information on the sheet of paper for another project. See below